unsunghippie
Member
I have a system consisting of 2 SCADA computers running RSView SE, a contrologix and and RFID scanner. Due to this equipment moving to China, I changed the IP addresses of all the components.
I have established communications with one of the computers (the one with studio on it), but upon bringing up the other computer, I get a Message Box from RSView SE Client stating "Failed to Load Services", and when looking at the application log in windows I get "The description for event id(0) in source (SAProject) cannot be found........ The following info is part of this event: SAGetService:Result of Server Framework::Get Service Provider 80004005.
I have quadruple checked the IP address, and the sharing of the C drive between the two computers. At this point I am at a loss.
Any thoughts are appreciated.
Edit:
Could this be a Factory Talk issue? I know nothing about Factory Talk.
I have established communications with one of the computers (the one with studio on it), but upon bringing up the other computer, I get a Message Box from RSView SE Client stating "Failed to Load Services", and when looking at the application log in windows I get "The description for event id(0) in source (SAProject) cannot be found........ The following info is part of this event: SAGetService:Result of Server Framework::Get Service Provider 80004005.
I have quadruple checked the IP address, and the sharing of the C drive between the two computers. At this point I am at a loss.
Any thoughts are appreciated.
Edit:
Could this be a Factory Talk issue? I know nothing about Factory Talk.
Last edited: