Mitsubishi FX3U-232ADP Modbus

pauly

Member
Join Date
May 2002
Location
South Wales,U.k
Posts
244
I am trying to configure a Modbus connection to a Mitsubishi FX3UC PLC via a FX3U-232ADP module and I have fell at the first hurdle. The Mitsubishi documentation talks about Modbus addresses in the range 00000H-FFFFH. How does this correspond to the 4001/400001 standard Modbus address range. Has anybody had experience with this? If so any help would be appreciated.
 

Similar Topics

hi friens, whwn i communicate fx3u - 232adp and Indusoft scada not all data registers commnicates , ot only communicats certain data registers,i...
Replies
0
Views
4,204
Bonjour, Je n'ai pas de communication modbus RTU vis la configuration ci-dessus. J'ai essayé les deux mode ch1 et ch2 mais rien ne fonctionne...
Replies
0
Views
112
Hello everyone; I have Mitsubishi PLC FX3U 32M in hydropower plant governor, an error message popped up when a technician was working on an...
Replies
2
Views
325
hmi keeps saying "insufficient sensor failed" after the machine runs for 60 seconds. its a fx3u-48m PLC. The plc is not giving any errors or...
Replies
14
Views
2,169
Hello All, I have been trolling through the Proface documentation to find an answer, but I read conflicting information. We have a...
Replies
8
Views
3,840
Back
Top Bottom