Hello Friends
We have a machine with a FP-X C30RD PLC. We are trying to get the program with FPWIN GR 2.940 to program a small change.
The program is uploaded but without comments.
In the botton bar a message appears " Information in the general memory is incorrect. Comments not uploaded."
Also. We have tried with FPWIN PRO 7, Whe We try "New project from PLC" a message appears " An error occurred while online: Information in the comment memory is incorrect."
After push OK a empty project is created, then We can select Online/Upload program code and PLC configuration...
The program is read but without comments. And I am not sure that this program is correct.
What We can do to get the comments or is it not possible?
Is there any way to know in what software was done?
Thanks in advance.
We have a machine with a FP-X C30RD PLC. We are trying to get the program with FPWIN GR 2.940 to program a small change.
The program is uploaded but without comments.
In the botton bar a message appears " Information in the general memory is incorrect. Comments not uploaded."
Also. We have tried with FPWIN PRO 7, Whe We try "New project from PLC" a message appears " An error occurred while online: Information in the comment memory is incorrect."
After push OK a empty project is created, then We can select Online/Upload program code and PLC configuration...
The program is read but without comments. And I am not sure that this program is correct.
What We can do to get the comments or is it not possible?
Is there any way to know in what software was done?
Thanks in advance.