vaidyanikhil24
Member
I have a simatic S7-200 smart PLC with SR20 CPU and ethernet port. I would like to interface it with my Vijeo citect 7.4. it would be really helpful if somebody can help me with that.
Interface Siemens PLC with Vimeo citect
- Thread starter vaidyanikhil24
- Start date
http://www.plctalk.net/qanda/showthread.php?t=41629
http://www.plctalk.net/qanda/showthread.php?t=31765
http://www.plctalk.net/qanda/showthread.php?t=95852
The above threads may help you out.
'Citect, on the other hand, is designed to run with most PLCs on the market. To run with Siemens PLCs, you need to purchase a separate driver.'
I hope this helps you out.
Regards,
http://www.plctalk.net/qanda/showthread.php?t=31765
http://www.plctalk.net/qanda/showthread.php?t=95852
The above threads may help you out.
'Citect, on the other hand, is designed to run with most PLCs on the market. To run with Siemens PLCs, you need to purchase a separate driver.'
I hope this helps you out.
Regards,
vaidyanikhil24
Member
OP
S7NT driver is supplied with citect. Can i use it for.communication
Similar Topics
Good morning fellow sea captains and wizards,
I am being asked to do the above and obtain 4 values from each slave, I know about the MRX and MWX...
hi.
i worked in korea ,
i used this project the fanuc robot.
but i don't know how interface ,
i hope some of tip .
I'm currently working on my 'Weight Sorting PLC Trainer' for my thesis.
I am using a thin beam force sensor to determine the weight of my object...
I am currently installing an Emerson make Delta V DCS as master and Siemens make S7 313C PLC as slave on Profibus. I have been successful in...
Hi,
I am looking to connect an Incremental Encoder to a PLC and have never done this before! I am experienced in using Digital IO, PLC Bits...
