ceilingwalker
Lifetime Supporting Member
Hello. I have an NJ101-9000 with NX I/O. I am trying to create a recipe for heat treatment, using ramp and soak times. Has anyone here done that with an NJ? I went through the reference manual, searched online, and did a google search here on this website but have found nothing. I am trying with just a basic ramp to a certain temperature in 1 hour, then set at that temp for 5 minutes, ramp up another 10 degrees........ . I am sure I will need a timer instruction but am not exactly sure. I haven't had to control a temp with just a PLC before. Usually the PLC would drive a unit like a Eurotherm Temp controller, which one would enter their parameters and the Temp control drove to that temp. Thank you for any and all advice.