Good Morning.
I will be designing a unwind station to provide material to a nip roll that runs at a constant speed once dialed in by the operator. There will be no rewind. The material is fairly prone to mechanical distortion.
I am hoping that I can find a servo controller or a VFD that has a predefined unwind function built in.
Do any of you guys have any suggestions?
Thanks
I will be designing a unwind station to provide material to a nip roll that runs at a constant speed once dialed in by the operator. There will be no rewind. The material is fairly prone to mechanical distortion.
I am hoping that I can find a servo controller or a VFD that has a predefined unwind function built in.
Do any of you guys have any suggestions?
Thanks