IPM motor w/ VFD in Sensor-less vector mode?

ganutenator

Lifetime Supporting Member
ganutenator
Join Date
May 2002
Location
kansas
Posts
1,440
There is a Permanent Magnet mode for the vfd, but it seems to run much better in sensor-less vector mode.
Anyone know if this will harm the Internal Permanent Magnet motor?
 

Similar Topics

ganutenator
dc injection - ipm motor (synchronous mtr)
We use dc injection in our synchronous motors to raise the motor windings 10 deg. above ambient. If we do this w/ a permanent magnet mtr, will it...
Replies
0
Views
1,138
ganutenator
ganutenator
T
Powerflex 753 Same Phase Output and IPM Overcurrent
Hi everyone, I have a AB Powerflex 753 powering a simple 480V permanent magnet motor using flux vector control (I believe it's the only control...
Replies
3
Views
1,327
tarik1978
T
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
100
kamenges
K
T
HMI shows motor running even though disconnect is on.
Here's what happened, Operator turned on the disconnect for an auger while it was still running to cut power. Auger DID in fact turn off, but the...
Replies
8
Views
322
TheColt46
T
N
Motor Seizing on Startup
Hello all, In my facility we have multiple 3HP 460V motors that are being controlled by VFDs which drive conveyor belts. The drives are randomly...
Replies
2
Views
194
Nexen
N
Back
Top Bottom