Nusco drive with proface hmi communication

kulmaint

Member
Join Date
Dec 2018
Location
AUSTRALIA
Posts
42
DEAR FRNDS i have NUSCO DRIVE MODEL IS NSD-33 NC SERVO DRIVER and PROFACE HMI MODEL is AGP3500-T1-AF 3280035-45.PLZ TELL ME HOW TO COMMUNICATE.THANKS
 
I'm not sure that you can. The Proface is going to want to talk to tags from your *PLC*, something that your drive probably isn't going to have.

Proface will talk Modbus, but I don't think that the Nusco drive will.
 

Similar Topics

Kindly, has anyone tried to control Lenze servomotors with Siemens S120 drives ? Any special hints ? Have some concerns for the resolver and servo...
Replies
5
Views
178
Hi , I am trying to replace an old inverter with a new one and its giving me issues . Once the new one was installed , the S7-300 PLC started...
Replies
3
Views
98
I am trying motor startup with pf525 drive by using wizard start over ethernet communication but during direction test it's showing control error...
Replies
3
Views
159
Dear We are working in AB Studio 5000 and the drive is a PowerFlex 755T. For this project I need to control a conveyor to a certain set point...
Replies
2
Views
116
Back
Top Bottom