Hi,
I'm having Panelview component C600 and Panelview component C1000 HMI. I have connected them in network using NET-ENI module through switch (Controller used is ML1200). Ideally my RsLinx should show both HMI's after adding their IP under Ethernet devices, However it is showing yellow question mark with red cross on it. I'm using RsLinx Classic Lite 2.59.00 CPR9 SR5. How could I solve this problem?
I'm having Panelview component C600 and Panelview component C1000 HMI. I have connected them in network using NET-ENI module through switch (Controller used is ML1200). Ideally my RsLinx should show both HMI's after adding their IP under Ethernet devices, However it is showing yellow question mark with red cross on it. I'm using RsLinx Classic Lite 2.59.00 CPR9 SR5. How could I solve this problem?
