Dear All,
Anybody can help me in communication between Fatek 20MAR2 & CBEH0A. The jumpers setting are JP1 is on left two pins (No password protected) & JP3 is on right two pins (forced boot operation mode). I tried with removing both jumpers but problem still same. The Ethernet cable i used is type b T568. Fatek Ethernet module config software detecting module successfully (shown in attached pic) but on online PLC via ethernet cable its showing connection failed.
please help
thanks in advance
Anybody can help me in communication between Fatek 20MAR2 & CBEH0A. The jumpers setting are JP1 is on left two pins (No password protected) & JP3 is on right two pins (forced boot operation mode). I tried with removing both jumpers but problem still same. The Ethernet cable i used is type b T568. Fatek Ethernet module config software detecting module successfully (shown in attached pic) but on online PLC via ethernet cable its showing connection failed.
please help
thanks in advance