NR16
Member
I have restore a PC with IFIX 3.5 and installed GE9 driver.
I have 4 PLC's and ping to the PLC is ok. The IFIX 3.5 is not communicating to the PLC's.
Is there any configuration that is required to set up the communication.
Any advise would be much appreciated.
Thanks in advance.
I have 4 PLC's and ping to the PLC is ok. The IFIX 3.5 is not communicating to the PLC's.
Is there any configuration that is required to set up the communication.
Any advise would be much appreciated.
Thanks in advance.