WireGuy1950
Member
I have searched the forum for the instruction to do this conversion and found and (I think) properly followed the instuctions I found in previous posts.
Initially, I had limited success. I opened the .mer file diectly as instructed, and then copied the ~mer.00 directory contents to a new .apa file that I created using the same name as the .mer file.
When I tried to view the displays tab (there should have been about 5 or 6 screens), none were present, the tags folder was empty, etc.
I tried to repeat the instructions with a new upload/file but now I cannot get the .mer file to launch at all.
Anyone have some suggestions?
Equipment: PV+1000, RSView Studio for RSView ME v 4.00.00 (CPR7)on W2K laptop.
Thanks
Initially, I had limited success. I opened the .mer file diectly as instructed, and then copied the ~mer.00 directory contents to a new .apa file that I created using the same name as the .mer file.
When I tried to view the displays tab (there should have been about 5 or 6 screens), none were present, the tags folder was empty, etc.
I tried to repeat the instructions with a new upload/file but now I cannot get the .mer file to launch at all.
Anyone have some suggestions?
Equipment: PV+1000, RSView Studio for RSView ME v 4.00.00 (CPR7)on W2K laptop.
Thanks