I have a new computer with Windows 7 x 64 bit OS.
It is running really well and have had virtually no problems so far.
The 32 bit mode works really well also for all programs so far installed.
I have installed my Omron CX-One in the main OS as I normally do. It is working fine so far and as the machine will only be used for development I do not have any driver issues at all.It installed in 32 bit mode fine.
It installed in 32 bit mode successfully. It is the only PLC software I will install directly in Windows as it causes no problems at all and fully shuts down when one exits.
I have Windows 7 x 32 bit mode to install on my laptop where 64 bit drivers are not available for communications and there would probably be issues.
I have other PLC software to install and it will be installed in XP Mode - shut down XP Mode and shut down drivers.
No problems with Siemsns, AB and Unity Pro not getting on with each other.
I clicked on 'XP Mode' and set XP up. I then wnet into Users/Bob/AppData/Local/Microsooft/Windows Virtual PC/Virtual Machines and changed the file names (.vhd & .vmc extensions) to Schneider Unity Pro.
Opens and works successfully.
When I click on XP Mode Windows now opens Schneider Unity Pro and does not start a new XP Mode Virtual Machine.
I wish to start a new XP Mode for other bPLC software - any ideas or do I have to just make a new Virtual Machine and set it up from scratch and fully load XP Pro?
I have tried copying, pasting and renaming but it does not work.
I have tried moving the Virtual Machine to another folder but then the Virual Machine does not work.
I have tried moving the Virtual Machine back to the original folder but it does not work.
Any help appreciated.
It is running really well and have had virtually no problems so far.
The 32 bit mode works really well also for all programs so far installed.
I have installed my Omron CX-One in the main OS as I normally do. It is working fine so far and as the machine will only be used for development I do not have any driver issues at all.It installed in 32 bit mode fine.
It installed in 32 bit mode successfully. It is the only PLC software I will install directly in Windows as it causes no problems at all and fully shuts down when one exits.
I have Windows 7 x 32 bit mode to install on my laptop where 64 bit drivers are not available for communications and there would probably be issues.
I have other PLC software to install and it will be installed in XP Mode - shut down XP Mode and shut down drivers.
No problems with Siemsns, AB and Unity Pro not getting on with each other.
I clicked on 'XP Mode' and set XP up. I then wnet into Users/Bob/AppData/Local/Microsooft/Windows Virtual PC/Virtual Machines and changed the file names (.vhd & .vmc extensions) to Schneider Unity Pro.
Opens and works successfully.
When I click on XP Mode Windows now opens Schneider Unity Pro and does not start a new XP Mode Virtual Machine.
I wish to start a new XP Mode for other bPLC software - any ideas or do I have to just make a new Virtual Machine and set it up from scratch and fully load XP Pro?
I have tried copying, pasting and renaming but it does not work.
I have tried moving the Virtual Machine to another folder but then the Virual Machine does not work.
I have tried moving the Virtual Machine back to the original folder but it does not work.
Any help appreciated.