Hi all,
A client has recently replaced a Micrologix 1200 on site. They installed the old Memory module and expected it to just run but it didn't.
So I need to load the program from the memory module and write to the processor.
However when I try to load from EEPROM from RSLogix 500 (Comms --> EEPROM --> Load from EEPROM) I get the error message "Loss of Comms - Configuration probably changed"
Am I missing something here? What do I need to do to copy the program from the memory module?
I also had a look at setting the processor to load the program from the Memory module on power up however it seems that in order to do this it is necessary to set the appropriate status bit BEFORE writing the program to the Memory Module.
I've spoken to the client and unfortunately the only copy of the program is the one which resides in the memory module .......
The information of the Memory Module from RSLogix Function file is attached
Any help appreciated
Greg
A client has recently replaced a Micrologix 1200 on site. They installed the old Memory module and expected it to just run but it didn't.
So I need to load the program from the memory module and write to the processor.
However when I try to load from EEPROM from RSLogix 500 (Comms --> EEPROM --> Load from EEPROM) I get the error message "Loss of Comms - Configuration probably changed"
Am I missing something here? What do I need to do to copy the program from the memory module?
I also had a look at setting the processor to load the program from the Memory module on power up however it seems that in order to do this it is necessary to set the appropriate status bit BEFORE writing the program to the Memory Module.
I've spoken to the client and unfortunately the only copy of the program is the one which resides in the memory module .......
The information of the Memory Module from RSLogix Function file is attached
Any help appreciated
Greg