OMRON C200HW-PRM21 communication cable

kalabdel

Member
K
Join Date
Feb 2015
Location
Ontario
Posts
1,108
Hello guys,

I need to change the configuration on an C200HW-PRM21
PROFIBUS-DP Master Unit and looking communication cable. Any one knows where to get one? Is there another way to configure the module or is this the only way?


Thanks
 

Similar Topics

S
omron c200hw-drm21-v1 problem
need help, Hi i'm new. My deviceNet master drm21-v1 show an error, E2, then the whole system will power off. The power supply come back...
Replies
1
Views
2,758
Jay Anthony
Jay Anthony
I
omron cj2m with scada comunication
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Replies
0
Views
15
ismail efe
I
J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
2
Views
38
BobB
BobB
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
220
KalvMavin
K
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
130
Mihir_007
M
Back
Top Bottom