thiefgold0913
Member
Hello everyone,
I am having some troubles with getting a powerflex 40 to run from a msg instruction thru a Ethernet connection from a micrologix 1100 and ethernet switch 1783-US05T . I am using a timer instruction that initiates all of message intstructions when PLC is turned on.
I have the timeout msg N42.3 set to 5 sec. I have the write logic msg set to N41:0 and I am using a mov instructions triggered by four separate inputs that are set for the stop,start,forward and clear fault functions to the drive. I have the speed reference write and read msg set to N41:2 along with a scaling instruction for the speed of the drive.
Is there something I am missing?
I am having some troubles with getting a powerflex 40 to run from a msg instruction thru a Ethernet connection from a micrologix 1100 and ethernet switch 1783-US05T . I am using a timer instruction that initiates all of message intstructions when PLC is turned on.
I have the timeout msg N42.3 set to 5 sec. I have the write logic msg set to N41:0 and I am using a mov instructions triggered by four separate inputs that are set for the stop,start,forward and clear fault functions to the drive. I have the speed reference write and read msg set to N41:2 along with a scaling instruction for the speed of the drive.
Is there something I am missing?