Hello,
I recently inherited some equipment into our plant. This equipment has a Compact Logix PLC, Yaskawa Motion Controller, and a GE QuickPanel (#IC754VBI12CTD-FG). I would like to change the IP addresses of these components so I can set them up on our plant network. I am able to change the PLC address, and the motion controller address, I Have the sofware for those. however, I have the Proficy software but don't have the Licence for it, Only running in Demo mode.
I should be able to change the QuickPanel Address through the Windows CE interface. But I need to change the Target PLC address so they can Communicate afterwards.
My Question is: Is it possible to change the IP address of the target PLC in Demo Mode, or is there another way I can change this?
This is the only GE QuickPanel in our plant. I don't really want to pay for another Licence just for this one touch panel. I have plans of replacing this panel with what I current use in our plant.
Any Help on this would be Appreciated.
Thanks
I recently inherited some equipment into our plant. This equipment has a Compact Logix PLC, Yaskawa Motion Controller, and a GE QuickPanel (#IC754VBI12CTD-FG). I would like to change the IP addresses of these components so I can set them up on our plant network. I am able to change the PLC address, and the motion controller address, I Have the sofware for those. however, I have the Proficy software but don't have the Licence for it, Only running in Demo mode.
I should be able to change the QuickPanel Address through the Windows CE interface. But I need to change the Target PLC address so they can Communicate afterwards.
My Question is: Is it possible to change the IP address of the target PLC in Demo Mode, or is there another way I can change this?
This is the only GE QuickPanel in our plant. I don't really want to pay for another Licence just for this one touch panel. I have plans of replacing this panel with what I current use in our plant.
Any Help on this would be Appreciated.
Thanks