Rslogix 500 on windows 10

BachPhi

Member
Join Date
Dec 2007
Location
Los Alamos
Posts
640
Rockwell’s official support for windows 10 is v11.

However, v9.05 installed fine on my PC.

No go for v8.4, interestingly v7.3 is good and with much smaller footprint ( 26MB)

If your PC has latest patches for Spectre-Metldown, RSLinx may stop working, if so, you may need to uninstall KB4056892 to get it working again.

Noted that v7.3 does not support Micrologix 1400
 
Last edited:
I try installing v8.4 again, which asked to uninstall v7.3 , also I bypass the required steps of FactoryTalk components , this time installation is OK.
8.4 is possible on windows 10 after all
 
I use RS500 V9.0 on 3 Windows 10 computers without issue.

The only Win10 issue I have ever had was upgrading RSLinx from 3.7 to a newer version - that I had to uninstall & reinstall 3.7.
 
I've been running v9.0 on my Win10 machine for a while as well.

I updated to 11 last month to see if there were any issues and it's been running fine ever since.
 

Similar Topics

I have been searching the forum for a thread I thought I read before, but can't find it. It had to do with RSLogix500 not running on Windows 7...
Replies
11
Views
2,921
I have a SLC-500 10 slot chassis with a 5/03 cpu for at-home training. I am trying to find rs logix 500 free software that I can use for longer...
Replies
3
Views
6,040
I have followed instructions for installing RsLinx RsLogix Emulate 500 RsLogix Micro English I have added the driver "EMU500 SLC 500 (DH485)"...
Replies
4
Views
8,770
Officially Rockwell only supports the following configurations for these Products: Emulate 5: Windows XP and Older, No support for Windows 7...
Replies
4
Views
11,884
Hello all, I just updated my RSLogix 500 from version 7.00 to Version 9.00. Now when I try to open up RSLogix 500 I get an error that states...
Replies
17
Views
14,622
Back
Top Bottom