Siemens LOGO!

wwtptech

Member
Join Date
May 2003
Location
Penticton, BC
Posts
46
Does anybody know if the Siemens LOGO analog expansion module AM2 will accept a self powered 4-20mA input as well as an input powered by the module.
The manuals are vague and I havn't got any answers from my supplier.

Daryl
 
Thanks Rob,

I have that drawing as well and it is straight forward. what I need to know is can I connect a 4-20mA signal from a source with it's own power supply?

Thanks
 

Similar Topics

Hi all, First, thank you for reading the thread. So I had a task as the following: An up-counter must be programmed as part of a batch-counting...
Replies
7
Views
242
Hi Lads, I want to implement a flood prevention system with my domestic water pump. The intention is to have the water pump cut off on a daily...
Replies
7
Views
1,022
We need a Really Simple and Cheap controller that has a display or a Web Interface where we can change some set points. We were thinking about a...
Replies
2
Views
989
hello i have LOGO! 12/24RCE and i am looking for a schematics of electronic board. Or if someone know what is the burned component on the photo.
Replies
4
Views
1,376
Hi, I'm no expert in PID regulating so I need some advise. I have a VFD controlled deepwaterpump that is maintaining the pressure in a closed...
Replies
24
Views
11,822
Back
Top Bottom