Hi guys anyone had this before?
Latest AX5103-xxxx-0011 xml files from Beckhoff's site added in the device repository using ABB's Automation Builder. Drive latest firmware. The drive is in Init as soon as the PLC is put in Run, the drive goes to PreOp with error F4A5. This is a SoE comms parameter error. I have check all the startus parameters and everything correct.
Also tried a Beckhoff CX1020 PLC communicating to this Beckhoff drive and works without problem. I am in communications with ABB and Beckhoff but no solution so far. Another seen this or recommend anything to try?
Thanks
Latest AX5103-xxxx-0011 xml files from Beckhoff's site added in the device repository using ABB's Automation Builder. Drive latest firmware. The drive is in Init as soon as the PLC is put in Run, the drive goes to PreOp with error F4A5. This is a SoE comms parameter error. I have check all the startus parameters and everything correct.
Also tried a Beckhoff CX1020 PLC communicating to this Beckhoff drive and works without problem. I am in communications with ABB and Beckhoff but no solution so far. Another seen this or recommend anything to try?
Thanks