Hello,
I was testing the alarms from the PLC to the QP+ by toggling on/off the shared variables in the PLC code while cross-checking the alarm display on the QP+ (I have around 172 alarms), everything was fine until the last 6 alarms. When I toggled either of the last 6 alarms, the QP+ got frozen. Cycling power helped put back the QP+ in service but it froze again when I did the same.
This did not happen with alarms above the last 6 ones. Could this be an overflow issue somewhere in the QP+ or in the alarm object itself ? I tried to increase the storage memory but it didn't help.
Does anyone has any suggestions ? Thanks.
I was testing the alarms from the PLC to the QP+ by toggling on/off the shared variables in the PLC code while cross-checking the alarm display on the QP+ (I have around 172 alarms), everything was fine until the last 6 alarms. When I toggled either of the last 6 alarms, the QP+ got frozen. Cycling power helped put back the QP+ in service but it froze again when I did the same.
This did not happen with alarms above the last 6 ones. Could this be an overflow issue somewhere in the QP+ or in the alarm object itself ? I tried to increase the storage memory but it didn't help.
Does anyone has any suggestions ? Thanks.
Last edited: