Lovell
Member
I have a PowerFlex 753 V14.002 connected to an L8X processor for control of it. I am trying to add a data link but I have not done so before with this new a drive. They seem to change how the datalinks are setup up with each new revision of the drive. I have been reading the manual but it is not clear to me where exactly to go to set it up. I have tried par 905 but it does not add anything to the data structure. I am using the built in ENETR for ethernet comms (Port 6). Does anyone have experience with setting these up in studio? I do not have CCW installed.
Thanks.
Thanks.