I have Schneider lexium 32 servo drive connected with BSH1004P21A2A motor. Motor is not running on jog and auto tuning mode at all. Show error after 5% limit exceeded something , plz help I am ist time working on Schneider servo product thanks
Schneider Lexium 32 servo drive
- Thread starter rohit_plc
- Start date
Similar Topics
Hi all,
I'm trying to control a Schneider servo drive, a Lexium ILA2K.
I need to find either the program "SE_Motion_ILx2_ETH_Vxxxx.ACD"
or the...
Should we use 'MC_Start_LXM' or 'ServoStart' FB
to Enable LExium-32A Servo Drive?
we, have used 'MC_Start_LXM' in our program but, without...
We have 6 lexium servo drives that are being controlled from a schneider m340 via canopen baud rate is 1mb. The drives take a commanded position...
http://rapidshare.de/files/48877581/BA_LANGI_.xls.html
i added my question to link..but shortly i can say it... how can i use Function bloks at...
Hello, As part of our project, we are using an M241 controller. This controller interfaces with an industrial computer and a router via a switch...