Hi All
I have abit of problem communicating with the Panelview Plus 1000. Would anyone to give me a hand please?
Setup:
Local Rack: CLX L55 v15, EtherNet/IP and CNB/E v11.2(node 1)
Remote Rack: CNB/E v11.2(node 2)
Panelview plus 1000 with 2711P-RN15S: which connected to both rack via the same controlnet. (node ?, no switches to set)
PC: connected to the EtherNet/IP
When I open RSLinx Classic v2.5 via ethernet, I can see all the modules on the local rack, and via controlnet, alo see all modules on remote rack, but I see no Panelview. Same applies when I use RSLinx Enterprise v4.00. However, If I hook panelview on ethernet, I can see it on both RSLinx Classic and RSLinx Enterprise. Moreover, on the network communicaton setup on panelview, I can only setup ethernet IP, but no controlnet for me to setup. Even RSNetworx for Controlnet dont' see the panelview.
In additoin, the PLC software loaded did not include panelview in the module tree (I thought I dont need scheduling on panelview, cause it's not critical)
Does anybody know what i need to do so I can see the panelview?
Moreover:
1) Do I HAVE to add panelview on RSLogix 5000 on the module tree?
2) Target Tab on RSViewME, the latest version of CNB is the CNB/D, but no E, can i assume CNB/E as CNB/D and choose the D version?
Many Many Thanks
John Lam
I have abit of problem communicating with the Panelview Plus 1000. Would anyone to give me a hand please?
Setup:
Local Rack: CLX L55 v15, EtherNet/IP and CNB/E v11.2(node 1)
Remote Rack: CNB/E v11.2(node 2)
Panelview plus 1000 with 2711P-RN15S: which connected to both rack via the same controlnet. (node ?, no switches to set)
PC: connected to the EtherNet/IP
When I open RSLinx Classic v2.5 via ethernet, I can see all the modules on the local rack, and via controlnet, alo see all modules on remote rack, but I see no Panelview. Same applies when I use RSLinx Enterprise v4.00. However, If I hook panelview on ethernet, I can see it on both RSLinx Classic and RSLinx Enterprise. Moreover, on the network communicaton setup on panelview, I can only setup ethernet IP, but no controlnet for me to setup. Even RSNetworx for Controlnet dont' see the panelview.
In additoin, the PLC software loaded did not include panelview in the module tree (I thought I dont need scheduling on panelview, cause it's not critical)
Does anybody know what i need to do so I can see the panelview?
Moreover:
1) Do I HAVE to add panelview on RSLogix 5000 on the module tree?
2) Target Tab on RSViewME, the latest version of CNB is the CNB/D, but no E, can i assume CNB/E as CNB/D and choose the D version?
Many Many Thanks
John Lam