Hello All
I have a SLC-5/04 that is controlled by an old Panelview 1400e communicating DH+. I have setup a 1761-NET-ENI ethernet adapter connected to the RS232 port configured DF1 Full duplex. I am able to make changes to program the SLC-5/04 Via ethernet. I am setting up Wonderware HMI to take the place of the Panelview 1400e using OI-ABCIP server. I have the F8, N10, B3, Timers and counter all working in the HMI. My problem is when looking to see a digital input or output I only see False even though it is True. Example I:1/2 is on but HMI show no change in status and when looking into SMC Archestra system managment cosole the input is not changing states, just stays false. I have never had this problem before, but this is the first SLC-5/04 setup for panelview. The other I have is a SLC-5/03 using same type ethernet device and a panelview plus
and it works fine in Wonderware. Hope not too long winded.
I have a SLC-5/04 that is controlled by an old Panelview 1400e communicating DH+. I have setup a 1761-NET-ENI ethernet adapter connected to the RS232 port configured DF1 Full duplex. I am able to make changes to program the SLC-5/04 Via ethernet. I am setting up Wonderware HMI to take the place of the Panelview 1400e using OI-ABCIP server. I have the F8, N10, B3, Timers and counter all working in the HMI. My problem is when looking to see a digital input or output I only see False even though it is True. Example I:1/2 is on but HMI show no change in status and when looking into SMC Archestra system managment cosole the input is not changing states, just stays false. I have never had this problem before, but this is the first SLC-5/04 setup for panelview. The other I have is a SLC-5/03 using same type ethernet device and a panelview plus
and it works fine in Wonderware. Hope not too long winded.
Last edited: