kerch
Member
Hey Everyone,
I'm kinda new at this but here's my situation:
I have a SLC 500 (1747-L40C) in an ARPAC shrink wrapper.
We've been having issues connecting our laptop to the processor. We use RSLinx then go to the RSLogix500 program.
We use the AB_KT-2 DH-485 driver. This is the only SLC that we use that the baud rate is different. We have to change it to 9600.
Anyhow, when I got to work tonight, the tech on 2nd shift was trying to connect to the SLC.
During his attempts to connect he was plugging/unplugging the connector on the front of the SLC. he said he saw a flash at one point then the CPU light started to blink.
I read some of the threads in here so I think that the program got wiped out and everything is back to the factory defaults.
We do have the program backed up and also on a disc.
I've been trying off and on for the last 5 hours to communicate with this thing so I can load the program into it but I'm not having any success.
I'd appreciate any and all suggestions.
If I don't respond to any questions, I will tonight when I return to work.
Thanks,
John
I'm kinda new at this but here's my situation:
I have a SLC 500 (1747-L40C) in an ARPAC shrink wrapper.
We've been having issues connecting our laptop to the processor. We use RSLinx then go to the RSLogix500 program.
We use the AB_KT-2 DH-485 driver. This is the only SLC that we use that the baud rate is different. We have to change it to 9600.
Anyhow, when I got to work tonight, the tech on 2nd shift was trying to connect to the SLC.
During his attempts to connect he was plugging/unplugging the connector on the front of the SLC. he said he saw a flash at one point then the CPU light started to blink.
I read some of the threads in here so I think that the program got wiped out and everything is back to the factory defaults.
We do have the program backed up and also on a disc.
I've been trying off and on for the last 5 hours to communicate with this thing so I can load the program into it but I'm not having any success.
I'd appreciate any and all suggestions.
If I don't respond to any questions, I will tonight when I return to work.
Thanks,
John