Controller Link Question! Omron cqm1h

I need some help about data link table configuration (DM) in the controller link module of cqm1h .
I read the programmer manual of cqm1h, and I made the example, but I can't write in the DM6400, this is a memory for read but not for write, I need to know in what program i can make this..

Could you tell what you trying to do?

Try this:
DIP switch 1 must be OFF
Change PLC mode to stop/programing and then write to DM read-write area.
This is possible with syswin3.4 or cx-programmer.

Hi, i'm trying to make a red with two plcs omron cqm1h by controller link communication whit automatic datalink, but I was trying to configurate the DM6400, for two nodes, but the module shown the led of link intermittent, I need to know the correct configuration for the DM, I wrote the following configuration but i don't know what was wrong.

DM6400 0010
DM6401 0000
DM6402 8600
DM6403 0010
DM6404 1000
DM6405 8200
DM6406 0200
DM6407 0001
DM6408 0003
DM6409 0000