Hello all,
I have been using RSView Studio for a month now. I have used a lot of information from this site to assist in making the displays, thanks guys! I have read most of the forum topics on RSView and have not seen my issue addressed previously.
I need to make a display for my project that takes a heartbeat of all the plcs. This project runs a large assembly line and if the users are experiencing issues they need to click on the heartbeat screen to see if any plcs are not running/available.
If I were creating a software application I would send a ping command to check the status of an IP. How should I do this in RSView? As an IT admin I feel more comfortable using vba code than tags but an willing to give it a go.
With proper regards.
(BTW, is there a RSS feed for this site? I have been unsuccesful in my attempts to locate it)
I have been using RSView Studio for a month now. I have used a lot of information from this site to assist in making the displays, thanks guys! I have read most of the forum topics on RSView and have not seen my issue addressed previously.
I need to make a display for my project that takes a heartbeat of all the plcs. This project runs a large assembly line and if the users are experiencing issues they need to click on the heartbeat screen to see if any plcs are not running/available.
If I were creating a software application I would send a ping command to check the status of an IP. How should I do this in RSView? As an IT admin I feel more comfortable using vba code than tags but an willing to give it a go.
With proper regards.
(BTW, is there a RSS feed for this site? I have been unsuccesful in my attempts to locate it)