defcon.klaxon
Lifetime Supporting Member
Hey guys,
I'm on site integrating for the first day on a project where I'm programming RX3i (CPU 305) controllers and have hit a snag. At the main water filter plant, they have a control panel that used to have four racks worth of 90-30 hardware. We've replaced it with RX3i hardware. When I load my code onto the controller, I get a fault and when I check the fault table, I see hundreds of repeated faults: one is "loss of, or missing rack" and then below that is "addition of rack". This repeats ad infinitum. I've attached a screen shot for reference:
Nothing seems out of place so I'm not sure what to look for and how to go about troubleshooting this. I'm wondering if the 1.0 under LOC is the rack in question? Any help is much appreciated. Thanks!
I'm on site integrating for the first day on a project where I'm programming RX3i (CPU 305) controllers and have hit a snag. At the main water filter plant, they have a control panel that used to have four racks worth of 90-30 hardware. We've replaced it with RX3i hardware. When I load my code onto the controller, I get a fault and when I check the fault table, I see hundreds of repeated faults: one is "loss of, or missing rack" and then below that is "addition of rack". This repeats ad infinitum. I've attached a screen shot for reference:
Nothing seems out of place so I'm not sure what to look for and how to go about troubleshooting this. I'm wondering if the 1.0 under LOC is the rack in question? Any help is much appreciated. Thanks!