Hello, I have a problem I can't solve so far.
I have read a few other posts but I did not find understood, something about my problem.
I have a pump that works in automatic mode. If pump is enabled after 2 seconds a feedback must enable an input at plc. If not must set the alarm and stop the pump.
The alarm must be cleared if pump and feedback are both enabled or disabled.
At this point, if pump does not return feedack, it stack into a loop, alarm and clear alarm..
I use Fatek plc.
Best regards
I have read a few other posts but I did not find understood, something about my problem.
I have a pump that works in automatic mode. If pump is enabled after 2 seconds a feedback must enable an input at plc. If not must set the alarm and stop the pump.
The alarm must be cleared if pump and feedback are both enabled or disabled.
At this point, if pump does not return feedack, it stack into a loop, alarm and clear alarm..
I use Fatek plc.
Best regards