KingPresident
Member
Super generic question...
I have an internet enabled device that shows me relevant curve data for my welds. The weld controller has the ability to display the data in a graph on the web browser, but all I get to my PLC is a pass/fail base on parameters in the weld controller. Can I get that Displayed value from the web browser to show up on my PanelView 700?
I have an internet enabled device that shows me relevant curve data for my welds. The weld controller has the ability to display the data in a graph on the web browser, but all I get to my PLC is a pass/fail base on parameters in the weld controller. Can I get that Displayed value from the web browser to show up on my PanelView 700?