Had an issue with the machine cutting stopping in the middle of auto running. So I go to the cabinet to plug up to the plc and well both of the connections for the ppi cable are being used.
1-Goes to the HMI
2-goes to the 2 drives for the belts.
Can I just disconnect the cable going to the hmi while the machine is running to observe a fault? Or will this cause the machine to stop?
1-Goes to the HMI
2-goes to the 2 drives for the belts.
Can I just disconnect the cable going to the hmi while the machine is running to observe a fault? Or will this cause the machine to stop?