Native commands to Cognex In-Sight from Allen Bradley ML1100 over EIP

Just for anyone who is struggling with this...

I ended up having to change the processor type from MicroLogix 1100 type B to type A. This gave me the same MSG command as the type in the Insight tech notes.

It’s not working perfectly.

Thanks
 

Similar Topics

I have an in-sight cognex camera connected via profinet, and it is up and running perfectly. However, for reasons too long to explain, I need to...
Replies
9
Views
6,226
Greetings All, I recently decided to start freelancing in Controls and Automation part time, most of my experience has been with Rockwell...
Replies
2
Views
55
Recently I have requested a quote from Magnetek for their Impulse Drives but can't raise a response from them. I've requested a quote FOUR TIMES...
Replies
3
Views
1,044
Hello All, Its been a long time since i've been in the trenches actually doing development. When i was developing I used PicsPro extensively for...
Replies
2
Views
1,122
Hello friends, I'm asking a new question here, after thinking a lot about my problem, I wondered if it wouldn't be easier for me to install new...
Replies
0
Views
708
Back
Top Bottom