miguelmaria
Member
NCM COM 1430 TCP V2.07 software donde puedo obtener gracias.
NCM COM 1430 TCP V2.07 para configurar SINEC 2XV9 450-1AU00 saludos.
NCM COM 1430 TCP V2.07 para configurar SINEC 2XV9 450-1AU00 saludos.
Last edited:
S5 CP143 SINEC software ?
- Thread starter antoine
- Start date
sigmadelta
Member
miguelmaria
Member
muchas gracias no se me instala bien sabes los pasos a seguir muy amable, podrias encontrar la version V 2.1
sigmadelta
Member
This is the only one I have. It should work
Send a screenshot of the problem you have trying to run the software.
Send a screenshot of the problem you have trying to run the software.
miguelmaria
Member
mandame un correo y te mando un word de los pasos que hago haber si alguno hago mal.
Similar Topics
Hi,
I'm ordering one of these this week, but wondering what lead I will need to connect them up?
Is it just a AUI 15 pin lead? Or will I need...
Hello!
Does this module need any supply card for the 15V? 15v fault lit and there is no voltage in the AUI port. I don't find any manual on this...
I have a WinCC V4.0 with a CP1413 card who is communicating with a CP143 (S5) over Sinec-H1.
This PC will be replaced. The new PC will be equipped...
I'm getting this message when I try to view the CP Status while online with it in the NCM software.
I've tried deleting the DB in the CP and then...
Hi,
I would like to find the procedure to setup PCLink2 (ISA card in PC) to communicate with Siemens CP143. I know that this card is very old...