Just received some new automation that was done in RS Logix 5000 ( Studio 5000 ) version 28. I tried to open other projects done in an earlier version , such as version 20.01 , and I get the following ......
Oven_Upload .ACD is configured in revision 20.01 . Logix Designer support for this revision is not installed . To open this project you must :
Cancel and install Logix Designer Support for firmware revision 20.01 or
Change the controllers revision and / or type in the project .
I thought that updating to version 28 would allow me to open earlier versions ?
Didn't earlier versions of RS Logix 5000 , have the earlier versions also ?
What is the normal corrective active around this ?
Thanks again , like always.
Oven_Upload .ACD is configured in revision 20.01 . Logix Designer support for this revision is not installed . To open this project you must :
Cancel and install Logix Designer Support for firmware revision 20.01 or
Change the controllers revision and / or type in the project .
I thought that updating to version 28 would allow me to open earlier versions ?
Didn't earlier versions of RS Logix 5000 , have the earlier versions also ?
What is the normal corrective active around this ?
Thanks again , like always.