alive15
Member
Good morning,
1- I am finding good use out of the Trend feature in Studio Logix 5K. Is there a way to export the graph into a pdf automatically after every cycle I run (I would automate the start and stop of the trend)? I know how to export into PDF manually, but would like to automate this through the software.
2- The data I need to collect would be plug depth vs. pressure exerted over a 2 second period. I am seeing pressure from a depth between 3.5 and 4.5 inches.
3- If I cannot automate the graph into pdf, would my PLC (1769-l27erm-qbfc1b) work fast enough to capture this data into an array of 100? For example, at 3.5 inches, psi = 50; at 3.51, psi = 52; at 3.53 psi = 60, and so on until 4.5? Then I would save the data of 100 points into a notepad through my Automation Direct HMI, and redo for each cycle.
1- I am finding good use out of the Trend feature in Studio Logix 5K. Is there a way to export the graph into a pdf automatically after every cycle I run (I would automate the start and stop of the trend)? I know how to export into PDF manually, but would like to automate this through the software.
2- The data I need to collect would be plug depth vs. pressure exerted over a 2 second period. I am seeing pressure from a depth between 3.5 and 4.5 inches.
3- If I cannot automate the graph into pdf, would my PLC (1769-l27erm-qbfc1b) work fast enough to capture this data into an array of 100? For example, at 3.5 inches, psi = 50; at 3.51, psi = 52; at 3.53 psi = 60, and so on until 4.5? Then I would save the data of 100 points into a notepad through my Automation Direct HMI, and redo for each cycle.