Mbeavers34
Member
I'm an old AB guy who is working on a CT021 Omron high speed counter. This has the markings of a dumb question but here goes.
I'm trying to read the counter data using the example program shown in the counter manual (page 115 ), however, how do address the = flag (N.O. contact before the R1 transfer complete).
Michael
Never mind I finally figured it out. It's P_EQ!
I'm trying to read the counter data using the example program shown in the counter manual (page 115 ), however, how do address the = flag (N.O. contact before the R1 transfer complete).
Michael
Never mind I finally figured it out. It's P_EQ!
Last edited: