GE Series One - Procedure for loading code from cassette tape?

defcon.klaxon

Lifetime Supporting Member
D
Join Date
Feb 2015
Location
Far NorCal
Posts
616
Hi guys, I have a client that has a GE Series One PLC that apparently needs the code re-loaded onto it; they mention that when they lose power, they sometimes need to reload the code onto the PLC.

The code is stored on a cassette tape, and they use a portable stereo to play it. They say they have a procedure for doing this, but they can't find it. Wondering if anyone has worked on these systems, and if you could provide some help for a procedure?
 
defcon.klaxon said:
Hi guys, I have a client that has a GE Series One PLC that apparently needs the code re-loaded onto it; they mention that when they lose power, they sometimes need to reload the code onto the PLC.

The code is stored on a cassette tape, and they use a portable stereo to play it. They say they have a procedure for doing this, but they can't find it. Wondering if anyone has worked on these systems, and if you could provide some help for a procedure?
Click to expand...

This is exactly what ours did. It started off as every blue moon,it would dump the program. It then escalated quickly to the point that it will no longer accept a program.

Better get the little display out and go through the program and write it down so you can upgrade later on. I’ll be replacing ours next week.
 

Similar Topics

U
SLC500 analog input value data type for EZ Series HMI
I cannot add SLC500 analog input tag (I: 8.3) to EZSeries Touch Panel Editor (V 5.3). I used all the listed tag datatype but it all says "Invalid...
Replies
8
Views
172
Markelov69
M
L
Micro series - ASCII
Hi, We couldn’t find anything specific, so am starting a new thread. I’m trying to migrate a config from a ML1400 to a micro820 & am experiencing...
Replies
1
Views
74
lostcontrol
L
S
Backplane Data Transfer Speed of CompactLogix 1769 Series?
Does anyone know what the data transfer rate for this series of CompactLogix PLC's? 1769-L24ER-QB1B to be exact. Cheers.
Replies
1
Views
88
robertmee
R
R
Hardy 6600 Series Zero with No Hardy Controller
Hello, I have a set of three tanks with their own trio of Hardy 6600 series load cells. Two of them have no issues with where they are at and...
Replies
3
Views
138
Ryan_Flowers
R
M
clear GE FAUNC PLC series 90-30 fault
Hi, Experts: We have 20 + years old GE PLC series 90-30 stop running (the run led not on and battery led not on) and HMI showing that "PLC has...
Replies
7
Views
187
Steve Bailey
Steve Bailey
Back
Top Bottom