Factory Talk View SE Alarm Pop-up

Good Morning All,

I'm a little bit new to RS5000 programming, and a LOT new to FT View SE. I'm trying to get an Alarm digital, to call up my Alarms screen. I have found the Factory Talk View Command 'blank' in the ALMD instruction, but I cannot find the wording/syntax that's supposed to go there, to accomplish triggering my Alarms screen to display.

Thanks!!!

Mike

http://www.plctalk.net/qanda/showthread.php?t=104971

The above thread may help you out.
Regards,

If your struggling, have an alarm screen navigate button on every screen, via a global object and change the background colour to say red when:

system\AlarmSummaryItemsUnacked > 0

This way the operator doesn't have a change of screen forced upon him, but the alarm screen button will flash red when alarms are present, drawing his eye to the problem but not disrupting his workflow.