urvinder_pal
Member
Hello Everyone,
I am new to Horner PLCs, I am trying to setup analog input and outputs but I am not sure how to assign the %AI and %AO to the terminal blocks, for example if i want to see a 0 to 10 volt signal from a potentiometer how can see the signal in the ladder logic.
what should be the settings like min and maximum and also does it have to be INT or DINT or real, how can i display this analog voltage thro an indicator on the screen setup.
Same is for analog output, where on the terminal block J2 shoul i wire analog in and analog out.
How should I/O configuration for channel 1, 2 ,3 and 4 should be set at ?
thanks for the help in advance.
Kanwar
I am new to Horner PLCs, I am trying to setup analog input and outputs but I am not sure how to assign the %AI and %AO to the terminal blocks, for example if i want to see a 0 to 10 volt signal from a potentiometer how can see the signal in the ladder logic.
what should be the settings like min and maximum and also does it have to be INT or DINT or real, how can i display this analog voltage thro an indicator on the screen setup.
Same is for analog output, where on the terminal block J2 shoul i wire analog in and analog out.
How should I/O configuration for channel 1, 2 ,3 and 4 should be set at ?
thanks for the help in advance.
Kanwar