Atlas Copco PowerMACs

panic mode

Member
Join Date
May 2003
Location
Toronto, Canada
Posts
1,963
Hi everyone,


I was wondering if anyone was using PowerMAC from Atlas Copco.
I need pinout of the XS0, XS1 and XS2 connectors (Harting).
The XS0 is 3-phase power input (it should be 6-pin connector).
The other two are part of the safety circuit ("I/O group connectors").
Atlas is unable to provide better documentation than attached sample.
They say that once we receive units, there should be some printed
documentation that might be in better shape. The thing is I don't
have time for this, I need info ASAP because delivery for those
products is already way behind schedule...
Thanx,

panic mode

xa connection zoom1.jpg
 

Similar Topics

It was hard trying to find the software ECT for this drive. Finally, I found it but since it is very old it is not intuitive at all. Is there a...
Replies
0
Views
90
Hi Guys, I'm looking for a download for the ToolsTalk software for atlas copco controllers (power focus). The laptop that had it died and of...
Replies
5
Views
3,005
Hi I´ve been looking around the web trying to find programming software for Atlas Copco DMC drive series..(Example: DMC 50720) This far I...
Replies
2
Views
2,465
Wizards, Has anyone used the wireless torque gun set up from Atlas Copco? I was asked to see if it would be an improvement to change over to...
Replies
2
Views
1,282
I'm most likely out of luck here, but I'll give it a shot to ask... Does anyone have the following software? PAM Tools SAM Tools ProMotion...
Replies
20
Views
6,896
Back
Top Bottom