Wes Gifford
Member
Trying to connect CTI2500 PLC to PVP6 via TCP/IP
PVP6 firmware v9.00 w/KEP v5.19
Programming PC (Win7) has KEP 5.19 and FTV9.0
KEP Quick Client successfully reads data from CTI
using std. ethernet cable with common domain address
FTV Test Application, using same cable correctly reads
and writes data.
BTW the tag list was originally created in KEP4.5 then
exported / imported to KEP 5.
Created and transferred *.mer to PVP by USB thumb drive.
Connected PLC to PVP with same cable - No data !!!
Same results when set up for serial connection.
Been on phone with RA/TechConnect about 4 hours.
PVP6 firmware v9.00 w/KEP v5.19
Programming PC (Win7) has KEP 5.19 and FTV9.0
KEP Quick Client successfully reads data from CTI
using std. ethernet cable with common domain address
FTV Test Application, using same cable correctly reads
and writes data.
BTW the tag list was originally created in KEP4.5 then
exported / imported to KEP 5.
Created and transferred *.mer to PVP by USB thumb drive.
Connected PLC to PVP with same cable - No data !!!
Same results when set up for serial connection.
Been on phone with RA/TechConnect about 4 hours.