alive15
Member
Good afternoon all, hope everyone is doing well. I have a mill cutter application which mills into our iron casting part. I am using duct hose 5314k36 from McMaster to collect the hot chips and shavings after every mill, but this one only lasts about 5 weeks before holes start appearing in the hose.
Does anyone recommend a stronger duct hose of any material from any company? Looking for a 10' piece or longer that can slightly flex on the ends, similar to picture attached. Our chip hose goes up vertically into a metal pipe which sends to the chip collector bin.
Thanks,
Does anyone recommend a stronger duct hose of any material from any company? Looking for a 10' piece or longer that can slightly flex on the ends, similar to picture attached. Our chip hose goes up vertically into a metal pipe which sends to the chip collector bin.
Thanks,