Trying to get a piece of equipment put back in to service. OLD VFD from this system has been scavenged so trying to add a new one to get it going again. Looking at what limited operator instructions that are available, it had two speed set points of 3,000 and 6,000 RPM's. (I am guessing 50hz and ~100Hz). Unit is only cycled for short periods of time. Short as in less than 5 to 10 minutes each hour. I need help in figuring which set of parameters to enter in to the VFD. Do I go with the 110Hz, 6600 RPM and 13KW values and expect the FLA to be around 27A?
Also, am I correct in my assumption that this is a 2 Pole motor based on 2,920 RPM value at 400VAC 50Hz?
Thanks.
Also, am I correct in my assumption that this is a 2 Pole motor based on 2,920 RPM value at 400VAC 50Hz?
Thanks.
Last edited: