easystreet
Member
Hell ALL,
I am having problems setting up comms between Redlion G306 and Automation Direct Click PLC.
If the drop numbers (and baud etc) are set identically in both the HMI and PLC then both the Tx and Rx on the PLC lights blink. (indicating PLC is ok?)
If the drop number assigned to the PLC slave is anything other than '0' (in the HMI comport set up as assigned to the Click) then I get CommError=2 on the HMI.
Because the numbering system on the Click starts at 1 and not 0 I can not get the lights to blink and the CommError to = 0 at the same time....???
Please Help Me!
I am having problems setting up comms between Redlion G306 and Automation Direct Click PLC.
If the drop numbers (and baud etc) are set identically in both the HMI and PLC then both the Tx and Rx on the PLC lights blink. (indicating PLC is ok?)
If the drop number assigned to the PLC slave is anything other than '0' (in the HMI comport set up as assigned to the Click) then I get CommError=2 on the HMI.
Because the numbering system on the Click starts at 1 and not 0 I can not get the lights to blink and the CommError to = 0 at the same time....???
Please Help Me!