Hey all, I have been looking through the forums and many other places, and while I have found a lot of information, nothing seems to specifically assist my situation.
I am trying to field diagnose a CPU 414-2DP (does not have a memory card in it) which is alone on a rack with a 407-0KA00-0AA0. I am using an MPI/USB cable S7972-0CB20-0XA0, with Step 7 Micro/Win V4.0.9.25.
In my SET PG/PC Interface, I have tried pretty much every combination to communicate with my adapter plugged into X1, but the only one that gets me anything is PC Adapter(MPI) with PG/PC is the only master on the bus selected, address 0, Timeout 30s, 187.5KBPS Baud, and highest station of 31.
With that set up, I get an UNKNOWN device showing up with an address of 16, but when I try to go any further than that, I get "No connection to the specified address could be established. Possibly an invalid or non-existent address."
Does anyone have any thoughts of my situation?
I appreciate the help, and this forum for all the information here.
I am trying to field diagnose a CPU 414-2DP (does not have a memory card in it) which is alone on a rack with a 407-0KA00-0AA0. I am using an MPI/USB cable S7972-0CB20-0XA0, with Step 7 Micro/Win V4.0.9.25.
In my SET PG/PC Interface, I have tried pretty much every combination to communicate with my adapter plugged into X1, but the only one that gets me anything is PC Adapter(MPI) with PG/PC is the only master on the bus selected, address 0, Timeout 30s, 187.5KBPS Baud, and highest station of 31.
With that set up, I get an UNKNOWN device showing up with an address of 16, but when I try to go any further than that, I get "No connection to the specified address could be established. Possibly an invalid or non-existent address."
Does anyone have any thoughts of my situation?
I appreciate the help, and this forum for all the information here.