Omron IO Address

Hi,

I am new for Omron PLC.
For now, I have a project using Omron CJ2M CPU35.
I have no idea how to find where is IO address.

Because there is no power for plc now, I cannot test. But I would like to know where are IOs


Thank you so much

Welcome to the Forum

The best resource for understanding addressing would be the W393 manual. This references the CJ1, but addressing is the same for the CJ2.

http://www.omron-ap.com/data_pdf/mnu/w393-e1-17_cj1h_cj1g_cj1m-cpu.pdf

Only place I could find a link to the manual was the Singapore site. You may need to register to download the manual. Registration is free.

Hope this will help.

OK, found the information in the CJ2 manual.

See section 8-1 in the manual linked below.

https://industrial.omron.ca/en/media/W473-E1-08_tcm824-110490.pdf