Hi everyone.
I'm having major issues with both channels on my micro, all of which are self inflicted. Firstly I've been having trouble settling a static IP using bootp. I've been able to set an ip twice out of many attempts but never disable DHCP. While trying to remedy the problem I found that I can manually enter an ip and subnet in the channel configuration properties tab by unchecking the enable bootp box. After setting this and power cycling the ethernet port is now unresponsive. The jack doesn't even light up when connected. I've already tried pinging and have tested my cable on a different component.
I then searched these forums and found that I should try to download a new project with the stock configuration. What happened though is that I've deleted the channel 0 configuration and now I can't communicate through that port either. I've also tried unplugging the battery and switching the micro off for 20 min to no avail. Did I just brick this thing?
I'm having major issues with both channels on my micro, all of which are self inflicted. Firstly I've been having trouble settling a static IP using bootp. I've been able to set an ip twice out of many attempts but never disable DHCP. While trying to remedy the problem I found that I can manually enter an ip and subnet in the channel configuration properties tab by unchecking the enable bootp box. After setting this and power cycling the ethernet port is now unresponsive. The jack doesn't even light up when connected. I've already tried pinging and have tested my cable on a different component.
I then searched these forums and found that I should try to download a new project with the stock configuration. What happened though is that I've deleted the channel 0 configuration and now I can't communicate through that port either. I've also tried unplugging the battery and switching the micro off for 20 min to no avail. Did I just brick this thing?