Hmi omron ns15-tx01b-v2

Dear Experts,

Could anyone explain the how does Omron HMI address setting (like pushbutton, data record, data insert) will be writen in Omron PLC, I'm new user for Omron PLC. Most of time I'm familiar with Mitsubishi PLC.

Thank you

Thiban

You need to get the manual for the PLC model you are working with. Then study the memory map for that PLC.

Thank you for the tips

Not sure what model of PLC you are using but here is a link to the manual for the CP1L series, I believe that most models will use the same memory map.
https://assets.omron.eu/downloads/m...it_(including_cp1l-j)_operation_manual_en.pdf
Look at section 4.
CIO bits are the real I/O, however, any unused bits can be used as internal memory if required.
Data Memory "D" can be used for values either int, real etc.
Aux area bits "A" can be used as internal memory bits Etc.
So addressing I would assume in the HMI would be CIO0-99 inputs CIO100-199 outputs (this will depend on actual I/O on the PLC, any unused can be used for internal memory bits but should not be required) the equivalent in Mitsi is X for inputs Y for outputs.
A000-959 can be used as internal bits (Flags) these are equivalent to M bits in Mitsubishi, D is the same for both.

IM USING OMRON CJ2H with HMI NS15-TX01B-V2,
I WOULD LIKE KNOW HOW ADDRESS ON HMI WIL WRITTEN ON PLC.
EXAMPLE FOR MITSUBISHI PLC Q SERIES, D*** , R*** OR M*** CAN BE WRITE ON PLC
RUNG. PLEASE ADVISE THIS ATTACH SCREEN SHOOT

Here is the manual for the NS series, see section 2 it explains the tags.
You can also import the symbols from CX programmer I believe
https://assets.omron.eu/downloads/manual/en/v4/v073_ns_series_programming_manual_en.pdf

Thank you for the tips