Panasonic drive Minas A5 family. Question

EStufC

Member
EStufC
Join Date
May 2019
Location
Kikuara
Posts
69
Hello everyone.

Perhaps someone know or faced with or had experience.

Currently we are running Panasonic drives A5 family with servo motors belonging to the same family (A5).


Will these drives struggle on same power/voltage/current servo motors, but belonging (A6) family?


Is there any motor's internal chip that says "I'm from wrong family"? Or?


Any help on this matter would be appreciated.
 
Last edited:

Similar Topics

J
Panasonic servo drive
Hi I have a Panasonic Minas A5 servo drive trying to test in free run a Panasonic A6 servo motor, But as there is a mismatch between the motor...
Replies
1
Views
1,652
gclshortt
gclshortt
H
Panasonic servo drive speed need to be changed
Hi. i have a Panasonic servo drive running in position control mode. i need to increase the speed of the servo motor. which parameter i can look...
Replies
0
Views
1,546
hinddhindsa
H
H
RS 232 Communication cable for MBDHT2510 Panasonic servo drive.
Hi, Anybody knows the pin out detail for RS232 Communication cable for Panasonic MBDHT2510 SERVO DRIVE (X2 PORT). Model no. of cable is...
Replies
0
Views
2,215
hinddhindsa
H
L
Panasonic SD30b servo drive
We have a customer that has acquired a couple of these servo drives, but with a limited manual. Google searching brings up a couple of sites, but...
Replies
0
Views
2,242
lostcontrol
L
P
Panasonic Servo drive communication problem with PLC
Hi All, We have panasonic make servo drive MSD043P1EA and we want communicate this drive with Schenider make PLC. but Drive does not have CAN open...
Replies
1
Views
5,264
anoop.kp
A
Back
Top Bottom